Monday, April 29, 2013

View MSU Snow Mold Plots at Treetops on May 2


Nancy Dykema
Research Assistant


It’s snow mold time again. We have rated and photographed the Tree Tops snow mold study and we have set the field plot viewing (“field day”) for Thursday, May 2. We will plan to meet at the Pro Shop at Tree Tops/Sylvan Resort at 10 am, as in the past, and will travel as a group to the plots. As far as air transportation goes, Joe recommends flying in to either Detroit (4 hr drive following flight), Flint (3 hr drive), or Traverse City (1 hr drive). 

The address to the resort is:

Treetops Resort
3962 Wilkinson Road, Gaylord, MI 49732
1-888-TREETOPS (888-873-3867)


Remember, we’re meeting at the pro shop, not the main resort, but this will get you to the property if you’re using a GPS system.


From the Gaylord exit off I-75 (exit #282), proceed east through Gaylord on Rt 32 until you reach Chester Rd (2-3 miles east of town). Turn left (north) on Chester Rd and proceed until it dead ends on Wilkinson Rd (1-2 miles). Turn right (east) on Wilkinson Rd and proceed about 1 mile to the resort entrance on the left. The pro shop is located on the first drive on the left. Lodging is available at the resort or at various hotels in Gaylord.

As always, be prepared for any weather conditions for the tour. Rain and cold weather gear is recommended. We will conduct the tour despite light rain or non-accumulating snow.

Feel free to bring as many associates along as you wish, but please RSVP by noon on Tuesday, April 30, with the number of people attending from your organization either by emailing me at dykema@msu.edu (best method) or by calling our lab at (517)353-9082 and leaving a message with someone in the lab.  If you RSVP by phone, please leave an email address where we can send a message if the plot tour is cancelled for some reason.

If you have any questions, you can contact us at 517-353-9082. Joe, Ron and I are looking forward to seeing you.

Sincerely,
Nancy Dykema
Research Assistant
Michigan State University

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.